Search found 11 matches
In the picture below, after enter config mode I unplug the wires for the button just to be sure it would not effect the board. I then rebooted my router and allowed it to boot up so I could watch it connect. At the end it just displays the same info over and over again. I might try my own server som...
I assume my Raspberry Pi and ESP8266 should not be trying to use the same location correct? I created a new location and have assigned it and the password that goes with it and am using the same server for everything.
- Thu Mar 03, 2016 4:19 pm
- Forum: General discussion
- Topic: Arduino IDE Sketches for ESP8266
- Replies: 1
- Views: 1162
I saw that there are Arduino IDE sketches for Arduino, is there anyway to get the libraries for ESP8266 so it would be easier to create our own sketches to work with Supla? For some reason the firmware provided for the ESP8266 is not consistent for me using the firmware flashing. Arduino IDE has bee...
Can you provide a list of the type codes and what features they add or enable? Also I have hooked up a humidity and temp sensor on GPIO 4 and don't seem to get the data anywhere.