supla.org

Kod: Zaznacz cały

//*****************************OPADY_DESZCZ*******************************************

double get_rain(int channelNumber, double t) {

    t = rainrate;    ----------------------########### CZEMU TEGO NIE CZYTA Z VOID COUNT ??????????????????????
  
    
}
//**********************************WYLICZ OPADY****************************************
void count() {
  // Grab the current ms count for common calculations
  unsigned long curtime = millis();
  
  // Make sure we don't record bounces
  if ((curtime - tiptime) < interval) {
    return;
  }
// How long since the last tip?
  unsigned long tipcount = curtime - tiptime;
  tiptime = curtime;
  
  // Calculate mm/hr from period between cup tips
  double rainrate = 914400.0 / tipcount;
  
  Serial.print("Cup tip: ");
  Serial.print(tipcount);
  Serial.println("ms");  
  
  Serial.print("Opady deszczu: ");
  Serial.print(rainrate/10);
  Serial.println("l/m2");  
  Serial.println("mm/h");  
}

Kod: Zaznacz cały

void setup() {
 
  Serial.begin(9600); 
 // Set up our digital pin as an interrupt
  pinMode(interruptPin, INPUT_PULLUP);
  attachInterrupt(digitalPinToInterrupt(interruptPin), count, FALLING);
    double rainrate;

Kod: Zaznacz cały

#define OLED_RESET 0
Adafruit_SSD1306 display(OLED_RESET); // GPIO5 - SCL , GPIO4 -SDA


const byte interruptPin = 12;
const int interval = 500;
volatile unsigned long tiptime = millis();
double rainrate;    $$$$$$$$$$$$$$$$$$$$$
unsigned long curtime;

Kod: Zaznacz cały

rainrate = 914400.0 / tipcount;

Kod: Zaznacz cały

double rainrate = 914400.0 / tipcount;