Gate Module

[gaurav]

I built the gate module firmware from ESP8266-IOT-SDK and flashed it on the nodemcu board. An led was blinking but there was no SSID broadcast. What am I doing wrong? Thank You in advance.

[pzygmunt]

You should switch the device to the config mode.

[gaurav]

I tried it but it didn't came to configuration mode.

[pzygmunt]

Do you have pullup on cfg pin ?

[gaurav]

I don't have any external pullup. I re-flashed the firmware now it works.

[pzygmunt]

You should have external pullup on cfg pin.

[gaurav]

Ok i will fix it in my circuit. Thank you

[gaurav]

I tried WeMos_gate_x2_DS18B20 in which cfg button is used to switch relay. But its not switching the relay. I provided the pullup to the cfg port. Also cfg button does not brings the device to the config mode.
Any guidance?

Thank you in advance.

[pzygmunt]

To bring the device into configuration
mode, press and hold button for at least 5 sec.

[gaurav]

No Luck.