Hi all!
I'm running a MEW-01 since 10 months without a problem. A few days ago I started to notice that I don't get data into my home assistant installation via MQTT. I checked the MEW-01 and found it blinking, I think 8 times. 10 minutes later it was up and running again. This happened a few times per day, mostly at noon and afternoon. Some more research showed this happened the last few weeks.
I checked connections power connection, I checked WLAN connection via App and it shows around 60%.
The MEW-01 is used for grid-neutral PV control, this is a pretty severe problem!
Any help would be appreciated!
MEW-01 3-phase monitor connection-lost
-
worldofmaya
- Posts: 10
- Joined: Mon Sep 27, 2021 11:06 am
One more thing I just noticed... Uptime is pretty low and seams to match the time dropouts.
You do not have the required permissions to view the files attached to this post.
-
worldofmaya
- Posts: 10
- Joined: Mon Sep 27, 2021 11:06 am
Hi!
I updated to version 2.8.51. But this didn't help...seams like it got even worse. It looks like it restarts, three red leds switch off and on again, than green light blinks one time slow and than 7 times. Is this some kind of blink code?
I just filmed it, link to Youtube via PM.
Thank in advance!
I updated to version 2.8.51. But this didn't help...seams like it got even worse. It looks like it restarts, three red leds switch off and on again, than green light blinks one time slow and than 7 times. Is this some kind of blink code?
I just filmed it, link to Youtube via PM.
Thank in advance!
-
worldofmaya
- Posts: 10
- Joined: Mon Sep 27, 2021 11:06 am
Code: Select all
ZAMEL MEW-01
LAST STATE: Registered and ready.,WiFi - Connecting...,WiFi - Connecting...,WiFi - Connecting...,WiFi - Connecting...
Firmware: 2.8.51
-
worldofmaya
- Posts: 10
- Joined: Mon Sep 27, 2021 11:06 am
Wifi signal strenght says 74% and RSSI -63