http://www.instructables.com

[astonix]

Hello,

UPDATE
After i tried few times, i think that my relay module is broken. Then i changed another type of relay module, it is works actually.
The relay is ON and Off based on the button pressed on the android apps.

Another issue is still remain :

3. When i tried to connect device to another Wifi network and try to switch to config mode using micro switch, it can not work. I cannot see SUPLA-ESP8266 on the network list. Even when i re-flashing the firmware.

I still trying to solve this one.

Will be update to this forum after accomplished.

[dantefo]

Hello,

UPDATE
After i tried few times, i think that my relay module is broken. Then i changed another type of relay module, it is works actually.
The relay is ON and Off based on the button pressed on the android apps.

Another issue is still remain :

3. When i tried to connect device to another Wifi network and try to switch to config mode using micro switch, it can not work. I cannot see SUPLA-ESP8266 on the network list. Even when i re-flashing the firmware.

I still trying to solve this one.

Will be update to this forum after accomplished.

Did you fix this? I have the same problem. I can not see the AP pressing the switch for 5 sec.

[astonix]

Hello,

UPDATE
After i tried few times, i think that my relay module is broken. Then i changed another type of relay module, it is works actually.
The relay is ON and Off based on the button pressed on the android apps.

Another issue is still remain :

3. When i tried to connect device to another Wifi network and try to switch to config mode using micro switch, it can not work. I cannot see SUPLA-ESP8266 on the network list. Even when i re-flashing the firmware.

I still trying to solve this one.

Will be update to this forum after accomplished.

Did you fix this? I have the same problem. I can not see the AP pressing the switch for 5 sec.

Hi, not fixed yet
Now i moved to another module : Gate/Gateway opening module.
It works fine with config button. Try it.

[dantefo]

ok.. thanks..
I didn't fix the problem, but I get it to work uploading the arduino code not the bin.