not for that model
this one has it on the other side
Sonoff Touch
-
elmaya
- Posts: 1485
- Joined: Wed Jun 27, 2018 5:48 pm
- Location: El Saucejo - Sevilla
this one has it on the other side
You do not have the required permissions to view the files attached to this post.
-
alvaro99
- Posts: 73
- Joined: Wed Jan 23, 2019 10:54 pm
- Location: Brzeszcze
Mam taki sonoff touch ale nie widzę tutaj esp.... jak to zaprogramować?
You do not have the required permissions to view the files attached to this post.
-
elmaya
- Posts: 1485
- Joined: Wed Jun 27, 2018 5:48 pm
- Location: El Saucejo - Sevilla
-
alvaro99
- Posts: 73
- Joined: Wed Jan 23, 2019 10:54 pm
- Location: Brzeszcze
Żeby wejść w tryb programowania trzeba zewrzeć gpio0 z gnd?
Gpio0 to ten drugi od lewej koło napisu wifi? Bo wg schematu jest to 10 w kolejce licząc od anteny czyli od lewego dolnego rogu?
Gpio0 to ten drugi od lewej koło napisu wifi? Bo wg schematu jest to 10 w kolejce licząc od anteny czyli od lewego dolnego rogu?
-
elmaya
- Posts: 1485
- Joined: Wed Jun 27, 2018 5:48 pm
- Location: El Saucejo - Sevilla
yes, connect Gpio0 to Gnd
You do not have the required permissions to view the files attached to this post.
-
alvaro99
- Posts: 73
- Joined: Wed Jan 23, 2019 10:54 pm
- Location: Brzeszcze
A w tym gdzie jest gpio0?
You do not have the required permissions to view the files attached to this post.
-
elmaya
- Posts: 1485
- Joined: Wed Jun 27, 2018 5:48 pm
- Location: El Saucejo - Sevilla
-
wsosniak
- Posts: 764
- Joined: Sat Jun 02, 2018 8:02 am
- Been thanked: 1 time
dla tego 3-kanałowego gdzie jest przycisk RESET , chyba można prościej , spróbuj z tego filmiku od 2:05 :
https://www.youtube.com/watch?v=yj3_6oKUh1w
https://www.youtube.com/watch?v=yj3_6oKUh1w